Jill Barnes
06-30-2019, 7:44 AM
Hi all, can anyone please tell me the minimum width of tail board so that I can use the Leigh dovetail jig D4 Pro to do a blind dovetail joint with the 14 degree bit. The recommended depth of cut for this bit, according to the User Manual , is 11mm.
I would like to do something like the attached layout. I am hoping to use a 35mm wide board, if physically possible with this jig, but suspect it is too small
I would like to do something like the attached layout. I am hoping to use a 35mm wide board, if physically possible with this jig, but suspect it is too small