Jet 14 Bandsaw Table Angle

[John Petersen]

I have a Jet 14 bandsaw which has the Carter bearing guides installed. The other day I needed to tilt the table to 45 degrees. I was unable to get to 45 because of interference between the table and the Carter lower bearing support. It would only go to 43.5 degrees. I was able to get to 45 degrees by raising the table support a little using washers. I put 2 washers under the table support at the 2 bolt positions and the 2 alignment pins. Has anyone else had this issue and what did you do to correct the issue?

Thanks John

[Myk Rian]

Your solution is the best I've heard in all the years I've been around.

[Michelle Rich]

I'd have cut a 1.5 degree wedge to prop the wood up 45