Ken Christianson
06-07-2019, 5:03 PM
Hello everyone,
Recently picked up a very rusty Powermatic 6" Jointer on Craigslist for $150, cleaned it up and wanted to share with the community. I've been referring to this site off and on over the years and have found great advice and suggestions, so I figured I should join and contribute.
Here's the refurbish job: https://spark.adobe.com/page/W1WwjWiVG0f0o/
I apologize for not having a great wide shot of the "before" condition; documenting the tear down was sort of an afterthought.
Also wanted to see if anyone out there has tried a Shelix cutterhead with this jointer, as I'm thinking of installing one. Let me know!
Recently picked up a very rusty Powermatic 6" Jointer on Craigslist for $150, cleaned it up and wanted to share with the community. I've been referring to this site off and on over the years and have found great advice and suggestions, so I figured I should join and contribute.
Here's the refurbish job: https://spark.adobe.com/page/W1WwjWiVG0f0o/
I apologize for not having a great wide shot of the "before" condition; documenting the tear down was sort of an afterthought.
Also wanted to see if anyone out there has tried a Shelix cutterhead with this jointer, as I'm thinking of installing one. Let me know!