justin sherriff
06-06-2019, 9:19 AM
Short question are these good side mount slides? https://quikdrawers.com/drawer-slides/drawer-slidesfull-extension-ball-bearing-slides/full-extension-ball-bearing-slidessoft-close-ball-bearing-slides/ez-open-10-soft-close-ball-bearing-slides I am using blum under mounts in the same peace. If not what would be a good match?
I am building a vanity
410948
2 drawers on left and doors on the right side. The top long slot was just going to be a fake drawer front since the sink needs room. But now I would like to make it into a shallow U shaped drawer that fits around the sink. 3 inch tall and 34 wide with about 2 1/4 inch inside drawer height should be a good place for a lot of small stuff.
410952410953
How should I go about making the curved part of the drawer back? should I resaw and do a bent lamination I am going to use 1/2 inch for the bottom and screw the sides and back on top to maximize my space.
I am building a vanity
410948
2 drawers on left and doors on the right side. The top long slot was just going to be a fake drawer front since the sink needs room. But now I would like to make it into a shallow U shaped drawer that fits around the sink. 3 inch tall and 34 wide with about 2 1/4 inch inside drawer height should be a good place for a lot of small stuff.
410952410953
How should I go about making the curved part of the drawer back? should I resaw and do a bent lamination I am going to use 1/2 inch for the bottom and screw the sides and back on top to maximize my space.