Patrick Irish
05-19-2019, 1:06 PM
How the heck do get this parrallel? I’m trying to sand some end grain boards and the motor side is taking a bigger cut than the open side.
The manual sucks. Just says to loosen the 4 allen heads and then turn the nut. Well what direction? Left or right? I don’t want to go one way and make things worse. I’ve tried with little luck.
Any tips? This is a year old minor use. My understanding there’s no adjusting the motor side, on the open end side by raising or lower the table via that nut.
I’m gonna try using a ruler with paper off the drum and lower it down, see if it contacts on motor side and then try on open side.
https://i.ibb.co/NL9D3Ks/1-FCE9713-C960-44-A1-A033-6-D5-A92-C391-AF.jpg (https://ibb.co/Q6PScMf)
The manual sucks. Just says to loosen the 4 allen heads and then turn the nut. Well what direction? Left or right? I don’t want to go one way and make things worse. I’ve tried with little luck.
Any tips? This is a year old minor use. My understanding there’s no adjusting the motor side, on the open end side by raising or lower the table via that nut.
I’m gonna try using a ruler with paper off the drum and lower it down, see if it contacts on motor side and then try on open side.
https://i.ibb.co/NL9D3Ks/1-FCE9713-C960-44-A1-A033-6-D5-A92-C391-AF.jpg (https://ibb.co/Q6PScMf)