Filip Winiewicz
05-15-2019, 1:27 AM
Hello,
I just bought a Woodfast pt260 which is a knock off the Record pt260. It's decent quality but the boards from planer were coming out with some twist, maybe 1mm rocking on opposite corners. I tried to tune up the infeed table, then outfeed table, then both, then using some shims and in result I think its completely out of control. Would you guys tell me how to set it up from scratch? I'm not sure where should I start, would it be alligning the outfeed table with the cutter and then trying to match the infeed table? Although in German I think this video shows best the adjustment system: https://www.youtube.com/watch?v=jiMkC6UZlXk
Regards,
Filip
I just bought a Woodfast pt260 which is a knock off the Record pt260. It's decent quality but the boards from planer were coming out with some twist, maybe 1mm rocking on opposite corners. I tried to tune up the infeed table, then outfeed table, then both, then using some shims and in result I think its completely out of control. Would you guys tell me how to set it up from scratch? I'm not sure where should I start, would it be alligning the outfeed table with the cutter and then trying to match the infeed table? Although in German I think this video shows best the adjustment system: https://www.youtube.com/watch?v=jiMkC6UZlXk
Regards,
Filip