Ryan Lloyd
05-05-2019, 12:10 AM
Hello folks,
Many users seem to be happy with their Hammer combination jointer-planers straight off the truck and thereafter, but where an issue does exist I am interested in the adjustment procedures. There has been much written regarding flattening the jointer beds and setting them coplanar, however I am unaware of any discussion about adjusting the planer bed to ensure it is parallel with the cutter. I presume the bolts connecting the single support-column with the planer table would need to be shimmed, but I would appreciate feedback from anyone who is familiar with the procedure.
Thanks for your time.
Regards,
Ryan Lloyd
Many users seem to be happy with their Hammer combination jointer-planers straight off the truck and thereafter, but where an issue does exist I am interested in the adjustment procedures. There has been much written regarding flattening the jointer beds and setting them coplanar, however I am unaware of any discussion about adjusting the planer bed to ensure it is parallel with the cutter. I presume the bolts connecting the single support-column with the planer table would need to be shimmed, but I would appreciate feedback from anyone who is familiar with the procedure.
Thanks for your time.
Regards,
Ryan Lloyd