Casey Van Wagoner
05-02-2019, 1:02 PM
Hey Guys,
I about to throw this laser through the wall. Seems like every time a boot it up, something new is wrong. Right now, when I draw a horizontal rectangle, the laser puts it out as a vertical rectangle. Sizing is good on it, it is just not the right way though. Everything functions, but axis is backwards. Any advice?
Using a 20w China laser with EzCad 2
I about to throw this laser through the wall. Seems like every time a boot it up, something new is wrong. Right now, when I draw a horizontal rectangle, the laser puts it out as a vertical rectangle. Sizing is good on it, it is just not the right way though. Everything functions, but axis is backwards. Any advice?
Using a 20w China laser with EzCad 2