Typically not one to gloat, but this Unisaw was the best deal I have found in a while

[Bob Falk]

Missing a hand crank wheel, fence, and motor not tested yet as I pick up tomorrow. You don't see many of these for free. I lucked out.

408442

[Matt Day]

Sweet!!!........

[Mike Henderson]

You can't do any better than "free". Congratulations!

Mike

[Allan Speers]

I haven't been here in many years, so I can't quite remember:

Is this the forum where we're not allowed to say
If so, then I will refrain...... :)

--------------------------------------

(Of course, I just scored a free Onieda cyclone with tons of ductwork, blast gates, and flex tubing, so who am I to pass wind? )

[Bill Orbine]

I haven't been here in many years, so I can't quite remember:

Is this the forum where we're not allowed to say
If so, then I will refrain...... :)

--------------------------------------

(Of course, I just scored a free Onieda cyclone with tons of ductwork, blast gates, and flex tubing, so who am I to pass wind? )

Yeah... this is the forum where we are not allowed to say........ but the gloaters still keep on gloating! Free is nice!

[Mike Kees]

Ok so you just topped my best deal on a Unisaw. I did buy one for $150 once,it was missing a fence also. I have a couple of hand wheels laying around .

[Bill Dufour]

I just bought a delta 12/14 tablesaw. The picture made it look much rustier on top then in real life. I was happy it included the jetlock fence not shown in the photo.
Bil lD.