View Full Version : Typically not one to gloat, but this Unisaw was the best deal I have found in a while
Bob Falk
04-22-2019, 2:50 PM
Missing a hand crank wheel, fence, and motor not tested yet as I pick up tomorrow. You don't see many of these for free. I lucked out.
408442
Matt Day
04-22-2019, 3:23 PM
Sweet!!!........
Mike Henderson
04-22-2019, 3:38 PM
You can't do any better than "free". Congratulations!
Mike
Allan Speers
04-22-2019, 3:46 PM
I haven't been here in many years, so I can't quite remember:
Is this the forum where we're not allowed to say
If so, then I will refrain...... :)
--------------------------------------
(Of course, I just scored a free Onieda cyclone with tons of ductwork, blast gates, and flex tubing, so who am I to pass wind? )
Bill Orbine
04-22-2019, 7:24 PM
I haven't been here in many years, so I can't quite remember:
Is this the forum where we're not allowed to say
If so, then I will refrain...... :)
--------------------------------------
(Of course, I just scored a free Onieda cyclone with tons of ductwork, blast gates, and flex tubing, so who am I to pass wind? )
Yeah... this is the forum where we are not allowed to say........ but the gloaters still keep on gloating! Free is nice!
Mike Kees
04-22-2019, 8:53 PM
Ok so you just topped my best deal on a Unisaw. I did buy one for $150 once,it was missing a fence also. I have a couple of hand wheels laying around .
Bill Dufour
04-22-2019, 11:17 PM
I just bought a delta 12/14 tablesaw. The picture made it look much rustier on top then in real life. I was happy it included the jetlock fence not shown in the photo.
Bil lD.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.