Table Saw Overhead Dust Collection

[Chris Kalnasy]

With using a riving knife, any recommendations for overhead dust collection or is it pretty much all DIY?

Grizzly G0651 if it makes a difference.

[Greg Parrish]

Check out this or other similar offerings

https://www.grizzly.com/products/Grizzly-Universal-Overarm-Blade-Guard-For-Table-Saws/T10113?iparcelcountry=US&gclid=EAIaIQobChMIxaaauZ_a4QIVhI2zCh32EgKqEAQYASAB EgJKo_D_BwE

[Chris Kalnasy]

Check out this or other similar offerings

https://www.grizzly.com/products/Grizzly-Universal-Overarm-Blade-Guard-For-Table-Saws/T10113?iparcelcountry=US&gclid=EAIaIQobChMIxaaauZ_a4QIVhI2zCh32EgKqEAQYASAB EgJKo_D_BwE

I just saw that. Looks sturdy. I wonder how easy it is to adjust for various thicknesses or move out of the way when not doing thru cuts.

[Greg Parrish]

Very easy. It lifts or swings 90 degrees with ease

408192



I just saw that. Looks sturdy. I wonder how easy it is to adjust for various thicknesses or move out of the way when not doing thru cuts.

[Rod Sheridan]

I use this one, it works well.

It swings out of the way, or you can lift it off the pivots if you want to remove it completely............Rod.

408193408194

[George Werner]

I had the Grizzly and it worked well, ended up switching to a Shark Guard so I could still use it for cutting narrower strips than the Grizzly would allow due to the size of the guard.

[Greg Parrish]

Makes sense. I had one on my PM66 before this and almost went with the shark guard on my Felder but decided to go this route so there wasn’t a physical connection to the table so I could use it during other operations like dado.


I had the Grizzly and it worked well, ended up switching to a Shark Guard so I could still use it for cutting narrower strips than the Grizzly would allow due to the size of the guard.

[Orlando Gonzalez]

I went with a Shark Guard on my Grizzly G0833P. Works well but not perfect but it's probably due to my dust collection system.

[Josh Kocher]

I drilled a hole and attached a Felder guard to my splitter.

Doesn't work with the guard attached for non-thru cuts, but works well on thin rips, DC is good.