Nick Andraka
04-15-2019, 3:37 PM
Epilog Radius 30W
It looks like the air ONLY goes to the little metal tube directed at the "cut".
The Radius manual says "20psi" but offers no CFM requirements.
I am looking at
https://www.californiaairtools.com/ultra-quiet-series-of-air-compressor-contractor-grade/3-5-hp-air-compressor/cat-1p1060sp/
for the compressor, it is oilless, 56db, and 1.6cfm at 40psi.
Is the Radius air "always" on?
BTW, I am missing the little metal tube, I see a threaded hole on the bottom of the alum block at the lens head.,, is this where the air assist tube screws in?
Thanks,
Nick
It looks like the air ONLY goes to the little metal tube directed at the "cut".
The Radius manual says "20psi" but offers no CFM requirements.
I am looking at
https://www.californiaairtools.com/ultra-quiet-series-of-air-compressor-contractor-grade/3-5-hp-air-compressor/cat-1p1060sp/
for the compressor, it is oilless, 56db, and 1.6cfm at 40psi.
Is the Radius air "always" on?
BTW, I am missing the little metal tube, I see a threaded hole on the bottom of the alum block at the lens head.,, is this where the air assist tube screws in?
Thanks,
Nick