Derek Cohen
04-07-2019, 9:07 AM
I have found the off switch for the Hammer K3 frustrating and potentially dangerous. It is tucked away under the rail and difficult to get to when working with the rip fence ...
https://i.postimg.cc/jqc25jhk/K3-1.jpg
The on-switch is also small ...
https://i.postimg.cc/QxMtWr4N/K3-2.jpg
... but I am not bothered much by this since switching on is a deliberate act, while switching off may need to be done quickly.
There is an off switch on the side by the panel, but this is only accessible when using the slider ...
https://i.postimg.cc/fTgbcgpc/K3-3.jpg
So today I built a paddle switch. This was to be a prototype, but it is good enough to stay on permanently ...
https://i.postimg.cc/4yWxF8dT/K3-4.jpg
https://i.postimg.cc/zvzf7mqj/K3-5.jpg
The body is made of Jarrah (it needed to be stiff and have some weight), and covered in red perspex. The end is a simple hinge.
It has been attached with double-sided tape, and it feels pretty strong.
The positioning allows the on-button to be accessed as easily as before ...
https://i.postimg.cc/85VcFJ3x/K3-7.jpg
... while the off switch is now within reach of a palm or knee ...
https://i.postimg.cc/XJcJ9N6q/K3-6.jpg
From the side, it can be seen that the off-switch is slightly higher than the on-switch. There is sufficient clearance to tap the paddle and depress the button.
https://i.postimg.cc/nhyc59HM/K3-72.jpg
I love the way it works!
https://i.postimg.cc/7ZGZmnrp/K3-8.jpg
Regards from Perth
Derek
https://i.postimg.cc/jqc25jhk/K3-1.jpg
The on-switch is also small ...
https://i.postimg.cc/QxMtWr4N/K3-2.jpg
... but I am not bothered much by this since switching on is a deliberate act, while switching off may need to be done quickly.
There is an off switch on the side by the panel, but this is only accessible when using the slider ...
https://i.postimg.cc/fTgbcgpc/K3-3.jpg
So today I built a paddle switch. This was to be a prototype, but it is good enough to stay on permanently ...
https://i.postimg.cc/4yWxF8dT/K3-4.jpg
https://i.postimg.cc/zvzf7mqj/K3-5.jpg
The body is made of Jarrah (it needed to be stiff and have some weight), and covered in red perspex. The end is a simple hinge.
It has been attached with double-sided tape, and it feels pretty strong.
The positioning allows the on-button to be accessed as easily as before ...
https://i.postimg.cc/85VcFJ3x/K3-7.jpg
... while the off switch is now within reach of a palm or knee ...
https://i.postimg.cc/XJcJ9N6q/K3-6.jpg
From the side, it can be seen that the off-switch is slightly higher than the on-switch. There is sufficient clearance to tap the paddle and depress the button.
https://i.postimg.cc/nhyc59HM/K3-72.jpg
I love the way it works!
https://i.postimg.cc/7ZGZmnrp/K3-8.jpg
Regards from Perth
Derek