Zach Dorsch
03-30-2019, 9:09 AM
Hello!
I recently acquired an Excalibur rip fence without the mounting jig. The rails require drill holes in the table top for mounting, so measurements are fairly critical.
Does anyone have this fence and/or the mounting jig that they could measure the distance from the saw table top to the mounting holes? The jig seems like nothing more than a pience of angle iron with a hole--so nothing complex on that end.
This is the fence: https://www.woodmagazine.com/review/saws/tablesaw-accessories/rip-fences/excalibur-extt4578-rip-fence
I have the instructions from vintage machinery and they only include the drill bit size, not the actual dimensions for the mounting holes or jig.
Fence instructions: http://vintagemachinery.org/pubs/detail.aspx?id=6160
Thanks,
Zach
I recently acquired an Excalibur rip fence without the mounting jig. The rails require drill holes in the table top for mounting, so measurements are fairly critical.
Does anyone have this fence and/or the mounting jig that they could measure the distance from the saw table top to the mounting holes? The jig seems like nothing more than a pience of angle iron with a hole--so nothing complex on that end.
This is the fence: https://www.woodmagazine.com/review/saws/tablesaw-accessories/rip-fences/excalibur-extt4578-rip-fence
I have the instructions from vintage machinery and they only include the drill bit size, not the actual dimensions for the mounting holes or jig.
Fence instructions: http://vintagemachinery.org/pubs/detail.aspx?id=6160
Thanks,
Zach