Cliff Polubinsky
03-28-2019, 4:17 PM
I've done some hammer veneering but this is the fist time I'm using a vacuum bag. The question I have is how do you keep veneer from shifting on the substrate?
I'm building a walnut sofa table and originally I hadn't intended to veneer the front aprons and drawer. But then I came across a piece of walnut that screamed out to be used to veneer the front. I understand that normally you cut the substrate larger than the veneer and trim later but the problem is that the parts are already cut and the joinery completed so the veneer will need to be cut to the size of the parts. I'd prefer not starting over if possible, although it I guess it could be done. Is there a way to insure the veneer doesn't shift after it goes into the bag? The veneer is shop sawn walnut, probably 3/32" going onto solid walnut substrate.
Thanks for all advice.
Cliff
I'm building a walnut sofa table and originally I hadn't intended to veneer the front aprons and drawer. But then I came across a piece of walnut that screamed out to be used to veneer the front. I understand that normally you cut the substrate larger than the veneer and trim later but the problem is that the parts are already cut and the joinery completed so the veneer will need to be cut to the size of the parts. I'd prefer not starting over if possible, although it I guess it could be done. Is there a way to insure the veneer doesn't shift after it goes into the bag? The veneer is shop sawn walnut, probably 3/32" going onto solid walnut substrate.
Thanks for all advice.
Cliff