Cliff Polubinsky
03-10-2019, 5:38 PM
I'm building a sofa table for one of my daughters. I've got the parts cut and fitted and joinery done. It's not glued yet.
405403
I was looking through my odds and end the other day and ran across a piece that would look really nice as a book match veneer across the aprons and drawer front. I was able to get a pair of 1/6" slices after sanding.
405406
The problem is that with the interior parts already fitted it's going to be tricky trying to fit a backer veneer to the back of the aprons and drawer front. Maybe cut holes in the backer for the drawer supports and braces to fit through? If the aprons are 7" x 4" and the drawer if 20" x 4" is it risking warping if I skip the backer?
All suggestions welcome.
Cliff
405403
I was looking through my odds and end the other day and ran across a piece that would look really nice as a book match veneer across the aprons and drawer front. I was able to get a pair of 1/6" slices after sanding.
405406
The problem is that with the interior parts already fitted it's going to be tricky trying to fit a backer veneer to the back of the aprons and drawer front. Maybe cut holes in the backer for the drawer supports and braces to fit through? If the aprons are 7" x 4" and the drawer if 20" x 4" is it risking warping if I skip the backer?
All suggestions welcome.
Cliff