Chris Damato
12-06-2005, 12:56 PM
Hello,
I finally got my DJ20 delivered yesterday. I am a little confused about something though. I understand that the top of the knives at their highest point must be parallel with the outfeed table. For whatever reason my outfeed table is slightly lower. Now, I understand how to raise it but this is where my problem is. Before I even raise the outfeed table, when I try and put the fence in it's 90 degree position, it hits the outfeed table and bottoms out. When I put a square on the table to check for fence squareness, it's slightly out. Should the fence be hitting the outfeed table or should there be a slight gap between the bottom of the fence and the outfeed table? I would assume there should be. If so, how do I adjust the fence so it is raised up a bit more?
I hope I did'nt confuse anyone with my description of my problem.
I finally got my DJ20 delivered yesterday. I am a little confused about something though. I understand that the top of the knives at their highest point must be parallel with the outfeed table. For whatever reason my outfeed table is slightly lower. Now, I understand how to raise it but this is where my problem is. Before I even raise the outfeed table, when I try and put the fence in it's 90 degree position, it hits the outfeed table and bottoms out. When I put a square on the table to check for fence squareness, it's slightly out. Should the fence be hitting the outfeed table or should there be a slight gap between the bottom of the fence and the outfeed table? I would assume there should be. If so, how do I adjust the fence so it is raised up a bit more?
I hope I did'nt confuse anyone with my description of my problem.