Michael Costa
02-25-2019, 4:22 PM
1) The obviously messed up in the initial design and the nut used to hold on the grinding wheel will rust. The wheel spins clockwise so it's my assumption that the nut is not reversed threaded?
2) Due to the cohesion (correct term?) properties of water, the water follows up the wheel and then spills down back into the reservoir but also all over the floor and workbench. Has anyone come up with a solution for this?
Thanks.
2) Due to the cohesion (correct term?) properties of water, the water follows up the wheel and then spills down back into the reservoir but also all over the floor and workbench. Has anyone come up with a solution for this?
Thanks.