Bill Dufour
01-10-2019, 1:42 PM
I have a 12 disk/belt sander that lives in the outfeed area of my tablesaw. It is not normally in the way but I would like to mount it so I can tilt it over 90 degrees so it goes below the tablesaw top height and is not in the way when. ripping plywood. I considered a hydraulic lift cart but it would leave it too tall in the down position. I know that Sears years ago made a three way rotating machine tool base. Some thing like. abae for a vertical/horizontal bandsaw is my idea. Probably need a counterbalance spring or lift strut.
Bill D.
Bill D.