Travis Fatzinger
01-06-2019, 3:09 PM
I bought a used Incra Twin Linear system a few years ago and I know the gentlemen produced quite a few drawers with it over the years.
While I've used the router table a lot, today was the first time I tried making dovetails. As you know there's a lot of steps involved but it went terribly. I finally realized the "Jumbo right angle fixture" is more like a parallelogram. No amount of fiddling with the nylon screws will take it up.
I just wanted to make sure I'm not missing something before I spend $45 on a new one. I'm not sure how it could have gotten so out of square.
400512400513
While I've used the router table a lot, today was the first time I tried making dovetails. As you know there's a lot of steps involved but it went terribly. I finally realized the "Jumbo right angle fixture" is more like a parallelogram. No amount of fiddling with the nylon screws will take it up.
I just wanted to make sure I'm not missing something before I spend $45 on a new one. I'm not sure how it could have gotten so out of square.
400512400513