Jim Dunn
12-02-2005, 12:30 AM
I have a PC 4112 dove tale jig and seem to have a problem. The boards when put together seem to be shifted slightly. It's not much just a 1/32 or less but then again it troubles me. I believe the trouble is with the edge guides. But as they are a set dimension I don't see any way around this. Or am I not seeing the whole picture. If I shift it towards the center of the jig will the sides of the board true up one to the other.
The instructions says to set it up with a 3/16" dimension from the left side of the top board but this would also move the inside of the side board as well:( Quite confusing. Especially if you don't have the same type of jig with the instructions in front of you.
I apologise if those of you without this jig and are confused, but so am I and I have all the instructions:confused::D;)
You can just see it in the second pic. The side and the front are just shifted, and I mean just slightly, but am I doing something wrong or not.
Jim
The instructions says to set it up with a 3/16" dimension from the left side of the top board but this would also move the inside of the side board as well:( Quite confusing. Especially if you don't have the same type of jig with the instructions in front of you.
I apologise if those of you without this jig and are confused, but so am I and I have all the instructions:confused::D;)
You can just see it in the second pic. The side and the front are just shifted, and I mean just slightly, but am I doing something wrong or not.
Jim