Jim Dunn
12-01-2005, 10:55 PM
Needed to joint the edges of the boards for a cabinet I'm building for SWMBO. As I don't have one yet I figured I just make do with a piece of MDF and a router. First I had to adjust the boards parallel to the MDF it was setting on. I accomplished this with a 5-6" depth mike. Worked pretty good as I was able to set the amount I wanted to remove and make it parallel to the back side of the board, which had already been jointed.
Don't let on that I can do this with tools I already have as a jointer and a planer are on my wish list. But, it can be done.:rolleyes:
Jim
Don't let on that I can do this with tools I already have as a jointer and a planer are on my wish list. But, it can be done.:rolleyes:
Jim