17-900 Delta Drill Press table not level

[Vince Shriver]

My Delta DP table has adjustment that allows movement left to right , but none that I can see that will allow me to move the table front to back. Aside from shimming a vise or another table atop the DP table, is there a way to get the bit square to the workpiece?

[Doug Hepler]

Just a stab in the dark. without knowing more than you wrote: consider re-seating the chuck on the spindle before thinking that you need to level the table. You can check runout with a straight rod and dial gauge. There are instructions on the internet about how to check runout and remove and replace the chuck.

Doug