George Bokros
10-21-2018, 4:57 PM
She wants a wooden small tray. I have two questions.....
I want to round over the top outside edge around all four sides, how would you do this? Run it top edge down on the router table after assembly?
I want to round over the four outside corners, how would you do this? They tray is being built with locking rabbet/dado outside corners. Would you round over the verticle corners on the sides, ends will be between the sides, before assembly?
Hope I have made this clear.
Thanks
I want to round over the top outside edge around all four sides, how would you do this? Run it top edge down on the router table after assembly?
I want to round over the four outside corners, how would you do this? They tray is being built with locking rabbet/dado outside corners. Would you round over the verticle corners on the sides, ends will be between the sides, before assembly?
Hope I have made this clear.
Thanks