View Full Version : plans/scale outline of a saw handle
Zahid Naqvi
11-27-2005, 12:26 AM
I have a gents saw that I plan to convert into a dovetail saw with an open handle, along the lines of Adria (http://www.adriatools.com/handsaw/dt_zoom.html). Anyone have scale drawing or outline of this handle or similar.
thanks
Mike Wenzloff
11-27-2005, 2:35 AM
Hi Zahid,
Cicking the image below will open a PDF. Grid is 1/4", but if you just cut it out after printing you can trace onto you handle wood. Make the thickness of your blank to fit, but I usually use 13/16" finished thickness for a DT saw. Some like a full 7/8".
Take care, Mike
http://wenzloffandsons.com/temp/open_handle_sml.jpg (http://wenzloffandsons.com/temp/open_handle.pdf)
Zahid Naqvi
11-27-2005, 8:04 PM
Hi Zahid,
Cicking the image below will open a PDF. Grid is 1/4", but if you just cut it out after printing you can trace onto you handle wood. Make the thickness of your blank to fit, but I usually use 13/16" finished thickness for a DT saw. Some like a full 7/8".
Take care, Mike
that's great Mike, thanks.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.