Richard Dooling
09-27-2018, 2:43 PM
Does anyone have a recommendation for an aftermarket table saw arbor flange? Mine is stamped steel and I want to replace it with a milled (flat and parallel) one.
Maybe the easiest option is a replacement flange from a higher end saw? I realize the dimensions would need to be appropriate for matching up to the press fit flange but I figure something must be out there.
Thanks,
Richard
Maybe the easiest option is a replacement flange from a higher end saw? I realize the dimensions would need to be appropriate for matching up to the press fit flange but I figure something must be out there.
Thanks,
Richard