PDA

View Full Version : Stock feeder2



dan petroski
09-27-2018, 9:05 AM
Finished my stock feeder and it works like a charm. Used the prototype wood drivers and stretched a inner tube band over them instead of solid rubber ones. Very smooth cuts with no interruptions in the cut. Limited to 3/4 stock give or take but that’s fine for me. Dan

Jack Lilley
09-29-2018, 8:31 PM
Dan after seeing some of the things you have built from scratch I have not doubt the stock feeder works great, you are genius.

dan petroski
09-30-2018, 8:13 AM
Necessity,Old arther is gearing my hands and Ma wants a wainscoting cherry back splash in her kitchen. A few hundred ft of rail and stile to run out of my very rare snowflake 🍒😁......Dan