Trey Tull
09-25-2018, 9:23 PM
I'm working on trying to get a "white" mark on some black ar mags. To test, I drew a 5 mm circle in Ezcad and started playing with settings. Well after about the gazillionth setting, I got it to mark ok. Then I noticed that the circle wasn't completely filled in.
393956
Have any of you ever experienced this and if so, do you mind schooling me on whats going on here? I have since changed a bazillion more settings trying to get it completely filled in but I'm not having any luck. I noticed this on some other images that I had lasered, but I had imported the artwork from corel, so I assumed it was something that I was doing wrong. Also, is that considered "white" on an ar mag? Seem more tan..
I then switched to another brand of ar mag and it didn't mark at all. Is this normal?
Thank you!!
Trey
393956
Have any of you ever experienced this and if so, do you mind schooling me on whats going on here? I have since changed a bazillion more settings trying to get it completely filled in but I'm not having any luck. I noticed this on some other images that I had lasered, but I had imported the artwork from corel, so I assumed it was something that I was doing wrong. Also, is that considered "white" on an ar mag? Seem more tan..
I then switched to another brand of ar mag and it didn't mark at all. Is this normal?
Thank you!!
Trey