View Full Version : Stand-Offs Question
Liesl Dexheimer
09-25-2018, 9:53 AM
I've only used stand-offs a few times and I've always used plastic as my substrate. Can metal (like AlumaMark) be used with stand-offs? I didn't think thin metal could be used because of space between the barrel and cap would be too great. Am I correct?
Trey Tull
09-25-2018, 1:46 PM
Put some tiny spacers/washers behind the AlumaMark that are the same diameter as the barrel. These could be cut on the laser.
Liesl Dexheimer
09-25-2018, 1:55 PM
Good idea, thanks.
Jerome Stanek
09-25-2018, 3:37 PM
the stand offs we use will tighten all the way down
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.