How do you make this cutting board?!

[Wade Lippman]

392468

Is it just a bunch of quadrilaterals glued together, or is there a technique I am not seeing?
It would have to be all endgrain to get it to glue up properly; wouldn't it?
How would you claim it?

[William A Johnston]

Go to MTM woodworking. He is in Russia but makes all kinds of unique cutting boards. He also will sell downloadable plans I'm sure he has some plans for a 3D board.

[Bruce Page]

I can't find the link but I have seen some great videos on making them on You Tube.

[Brian Nguyen]

It's just end grain cuts at an angle--I forgot the exact angle, maybe 60? Then trim the edge, flip, glue together to achieve the 3D effect. I probably simplified that by a lot so here's MTM's video: https://www.youtube.com/watch?v=5n0LdU8ZOJU&vl=en

[Wade Lippman]

Fascinating video!
Thanks.

[Randy Heinemann]

Alex Snodgrass from Carter Bandsaw Products passed out a 2-page set of directions at the Woodworking Shows over the past year or two. There may be a reference on the Carter Products website or maybe even a video on YouTube. Based on his demos, brief discussion, and information sheet, getting the final result requires a lot of precision and a couple of "tricks"; doable, but not as easy as it looks. It's a very nice look though.

[michael langman]

Nicest cutting board I have ever seen. Will definitely try to make one. Thanks for the question,and video Wade& Brian.