Cutting/Corel ???

[brian fithian]

I have a few Vector drawings that i run quite a bit. 2 out of 5 of them skip all around cutting. What did i do wrong in the file ?

[Joe Pelonio]

Did you try another file to make sure it’s the artwork? Mine did that once, years ago, and it was a failed tube. About $2,300 from Epilog. How old is yours? I hope I’m wrong.

[brian fithian]

Joe, just replaced tube last year. No problems cutting or engraving, just a couple of these files skip around. Still cuts good but, takes more time

[Kev Williams]

By 'skip around' you mean it stops in one place, goes to another, then stops, goes to another--yes?

If so, and they're DXF files, then it's possible all the sections are disconnected-- if that's the case, they just need to be connected...

[Patrick Gardner]

In coreldraw,
- open the object manager
-ungroup the drawing
the individual vectors will be listed.
the list will be cut from the bottom to the top.
These can be arranged to cut in any order.
I hope this is correct for you as well

[brian fithian]

Thanks Patrick,i will give it a try