View Full Version : Cutting/Corel ???
brian fithian
06-28-2018, 6:45 PM
I have a few Vector drawings that i run quite a bit. 2 out of 5 of them skip all around cutting. What did i do wrong in the file ?
Joe Pelonio
06-28-2018, 7:25 PM
Did you try another file to make sure it’s the artwork? Mine did that once, years ago, and it was a failed tube. About $2,300 from Epilog. How old is yours? I hope I’m wrong.
brian fithian
06-28-2018, 7:59 PM
Joe, just replaced tube last year. No problems cutting or engraving, just a couple of these files skip around. Still cuts good but, takes more time
Kev Williams
06-28-2018, 10:58 PM
By 'skip around' you mean it stops in one place, goes to another, then stops, goes to another--yes?
If so, and they're DXF files, then it's possible all the sections are disconnected-- if that's the case, they just need to be connected...
Patrick Gardner
06-29-2018, 1:56 PM
In coreldraw,
- open the object manager
-ungroup the drawing
the individual vectors will be listed.
the list will be cut from the bottom to the top.
These can be arranged to cut in any order.
I hope this is correct for you as well
brian fithian
06-29-2018, 2:24 PM
Thanks Patrick,i will give it a try
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.