tom suica
06-22-2018, 2:44 AM
Sorry if/for the/this is an ignorant question. I am sure with hours more of research I could probably figure it out. Who what where and how do I add variable speed to this saw? Is it a simple matter of adding an inline dimmer switch? Sorry if that is a dumb idea or would not work. Let me know It is a single phse motor.. Is it a matter of adding a potentimeter in line after the run capacitor? 1/10 hp 60 hz 1.8a 1750 rps which is running like a banshee.
Is it a matter of using multiple run capacitors? Lower uF rating? the one that is on it right now is a 10uF and was replaced after it died with same thing that as on there I cannot be sure it was original. Now the motor is staying coo and running with hella power.
I have been looking for some reading about how to match a capacitor to a motor. or how to choose a cap that may run the motor at a slower speed but still have power not heat it up too much. I am not sure the 10uF cap is original I am pretty sure though. let me know some thoughts.
Is it a matter of using multiple run capacitors? Lower uF rating? the one that is on it right now is a 10uF and was replaced after it died with same thing that as on there I cannot be sure it was original. Now the motor is staying coo and running with hella power.
I have been looking for some reading about how to match a capacitor to a motor. or how to choose a cap that may run the motor at a slower speed but still have power not heat it up too much. I am not sure the 10uF cap is original I am pretty sure though. let me know some thoughts.