Howard Henderson
06-08-2018, 7:09 PM
Hi All -
I’ve got a Delta combination 12 inch disc, 6x48 belt sander and need to change it to 120 volts.
The data plate on the motor showed the proper way to rewire the leads. And I moved the transformer primary pigtail from the 230 tap to the 200 tap (per the Rockwell 24 volt magnetic motor control document).
But the motor seems to not be getting any power is (it would barely spin when I first tried it before realizing it was on 240 and me rewiring). If I manually push the contractor it will hum, but not spin.
Am I missing some other step? The document says something about change the heater elements in the overload block, but doesn’t really say what exactly to do to change it.
Thanks for any advice,
Howard
I’ve got a Delta combination 12 inch disc, 6x48 belt sander and need to change it to 120 volts.
The data plate on the motor showed the proper way to rewire the leads. And I moved the transformer primary pigtail from the 230 tap to the 200 tap (per the Rockwell 24 volt magnetic motor control document).
But the motor seems to not be getting any power is (it would barely spin when I first tried it before realizing it was on 240 and me rewiring). If I manually push the contractor it will hum, but not spin.
Am I missing some other step? The document says something about change the heater elements in the overload block, but doesn’t really say what exactly to do to change it.
Thanks for any advice,
Howard