View Full Version : Another just curious............. dowell plates
lowell holmes
06-05-2018, 6:41 PM
Do you use them. I have two, one I made and a Lie Nielsen. I have not joined any boards recently,
but I think I will make some practice joints in case I need to do it again for real.
Mike Cutler
06-05-2018, 6:49 PM
Do you use them. I have two, one I made and a Lie Nielsen. I have not joined any boards recently,
but I think I will make some practice joints in case I need to do it again for real.
I have the LN version. I can't say I use it very much, but I know right where to find it if I do need it.
Van Huskey
06-06-2018, 12:25 AM
The only time I use mine is when I pin joints and I want the dowel to match or contrast since it is visible, I can't remember the last time I did this. Unlike Mike I am not sure where mine is, I know where it should be but not having put hands on it for so long I wouldn't bet on it being there.
Andrew Hughes
06-06-2018, 12:30 AM
I use mine mostly for draw bore joints.
When the dowel come out crooked or snakey it's a good thing.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.