Delta Versa-feeder wheel replacement

[William Flather]

i am trying to replace the drive wheels on a Delta Versa-Feeder.
Manual shows removing the retaining ring and lifting out the wheels. No other washer or retaining parts are shown.
I've removed the retaining ring but the wheels still seem to be held in place by another washer that I can't figure out how to remove.

Has anyone else done this and have any suggestions?

[Mike Heidrick]

https://www.ereplacementparts.com/delta-36865-type-stock-feeder-shaper-parts-c-3275_4046_4079.html

You following these parts?

[William Flather]

I'm having a hard time finding an exploded parts diagram that I can actually read. The manual shows this attached for replacing the drive wheels:

387079

[William Flather]

.....Problem solved. Seems I just needed to be persistent in applying pressure under the wheel (using flat screwdriver) to force the cogs around the flange that holds the retaining ring in place.
I think the original wheel must have swollen just enough to not slip off easily. The replacements slid right on.
Photo shows old wheel in place (minus the yellow tire that completely disintegrated). Black flange was holding the wheel in place by just a small fraction of an inch.

387086