PDA

View Full Version : Quick Flip Stops



glenn bradley
05-24-2018, 5:25 PM
I tend to share these things when I happen to be using them. If I've shared this before, please ignore ;-) The things are handy for 'production' runs when I need a lot of something with a similar dimension but, different lengths.

386422

For those who don't have commercial versions, these can be made from scrap milled to 1" x 1" square x 3-1/2" and 1-1/4" long pieces.

386421

I use a 1/4" bolt and lock-nut for the axle and to set tension. It should move easily enough to be trouble free but, with enough resistance to stay up and out of the way when you want that.

386425

The ends of the long piece need to be rounded for pivoting clearance.

386424

I put sand paper on both sides of the clamping "leg" since I use them in both positions.

386423

The kind of nest with each other in a drawer until needed.

Carlos Alvarez
05-24-2018, 6:57 PM
Pretty neat. I have top tracks on all my stuff, and lots of t-bolts, so I think I'll make a few that can just do into tracks. I often find myself wanting one that goes to the other direction (stop on the other side of the mount block).