Doug Hobkirk
05-22-2018, 3:35 PM
I have a Stanley 112 in nice condition. The iron has about a 60° bevel at one end and is square at the other end. Working at the square end, I tried to turn a bur using a good burnisher.
I clamped the iron in my typical wood workbench end clamp, using another plane blade at the other end to keep things parallel.
I filed it square (like I would a card scraper).
I kept the angle around 5-10 degrees and stroked the burnisher full length.
Note: It sure is easy to hit my knuckles, especially if I am putting a lot of down force.
I feel a slight bur after a few strokes, but it feels just about the same after 20-30 strokes.
I tested the scraping holding the iron by hand (so so) and in the plane body also (worse).
It doesn't seem like I'm being very effective.
Any general advice?
Am I correct in thinking that I should be able to turn a bur on both sides of the square end?
What is the 60° end used for?
Thanks.
I clamped the iron in my typical wood workbench end clamp, using another plane blade at the other end to keep things parallel.
I filed it square (like I would a card scraper).
I kept the angle around 5-10 degrees and stroked the burnisher full length.
Note: It sure is easy to hit my knuckles, especially if I am putting a lot of down force.
I feel a slight bur after a few strokes, but it feels just about the same after 20-30 strokes.
I tested the scraping holding the iron by hand (so so) and in the plane body also (worse).
It doesn't seem like I'm being very effective.
Any general advice?
Am I correct in thinking that I should be able to turn a bur on both sides of the square end?
What is the 60° end used for?
Thanks.