PDA

View Full Version : Marks on a laser tube



Jack Cope
04-16-2018, 10:52 AM
Hello,

I've used this forum for a while now and its been very helpful with getting stuff in my workshop running but this is my first time posting! I've just got a new laser cutter and I've noticed the tube has developed marks as seen in the attached photo.

Should I be concerned? I've not used this sort of tube (CO2) before so I'm not familiar with them and a quick look online only mentions marks being a bad thing!

Dave Sheldrake
04-16-2018, 4:04 PM
Usually just an uneven coating of catalyst on the inside of the resonator core....

Jack Cope
04-16-2018, 6:41 PM
Thanks, any way to tell? Its a brand new tube and obviously didn't come like that so it was worrying to see!

Dave Sheldrake
04-16-2018, 6:56 PM
Just one of those things that happens with lower cost tubes to be honest, all DC tube makes occasionally throw out a wobbler...it won't really affect very much in general