View Full Version : Skew Rabbit sub fence
Mike Cary
04-04-2018, 11:18 AM
Is sub fence the right term? Anyway, I need to cut some raised panels for drawer bottoms using my skew rabbit plane. I haven't done this procedure yet. What angle should I cut the subfence to attach to the fence?
Thanks,
Mike
Patrick Chase
04-04-2018, 1:24 PM
Is sub fence the right term? Anyway, I need to cut some raised panels for drawer bottoms using my skew rabbit plane. I haven't done this procedure yet. What angle should I cut the subfence to attach to the fence?
It seems to me that only you can answer that, since it depends on what angle you want to apply to the raised section. It would usually be pretty small (single digit degrees), though.
Derek Cohen
04-04-2018, 2:36 PM
Mike
It's all been done before ...
http://www.inthewoodshop.com/Furniture/Raisingapanel_html_50ead493.jpg
I am not sure what the angle is, but here is the link: http://www.inthewoodshop.com/Furniture/Raisingapanel.html
Regards from Auckland
Derek
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.