PDA

View Full Version : Laser stops cutting & continues with just a line



Debbie Sweet
03-31-2018, 5:22 PM
Hello

I haven't been on here awhile but I have a quirky problem that I'm hoping maybe someone has experienced and knows what it is so it can be fixed.

I have a GCC Explorer refurbished -15 months of useage. I have experienced a problem during cutting acrylic. It will be cutting and suddenly stops and continues with marking a line instead. So it looks like it looses power to a point but enough to continue the cut but with a line scribed into the material. I don't think it's the laser tube loosing power because it will continue on for hours without it happening again (cut and etch) everything beautiful. I have cleaned everything - looked for loose wires. Alignment is fine. I've been told it could be the RF board but all the connections are fine unless it's a capacitor going bad.

If someone has seen this or thinks of anything please let me know - most appreciated:)