Nate Miller
01-16-2018, 8:56 PM
There is a sort of thin washer that fits in where the cutter head attaches and it looks like I need a new one. You can see the washer in the photo just below where it is supposed to sit.
It is a model 6001 six inch jointer.
Is it a bad idea to just put it back together as is? And not worry about the busted washer?
The washer is much thinner than an actual washer so I do not think finding a similar diameter washer would work.
It is a model 6001 six inch jointer.
Is it a bad idea to just put it back together as is? And not worry about the busted washer?
The washer is much thinner than an actual washer so I do not think finding a similar diameter washer would work.