View Full Version : Delta Drill Press- new problem
Tom Norton
01-16-2018, 1:33 PM
Well in the process of getting the bearing off the spindle was damage. Now as I search I am finding it is an obsolete part.
I have been searching but with no luck.
Anyone know of a source for obsolete Delta parts?
Marc Jeske
01-16-2018, 1:55 PM
You should find helpful info at Vintage Machinery / OWWM.
http://www.vintagemachinery.org/
Marc
Larry Komroff
01-16-2018, 2:12 PM
You might want to check http://http://www.renovoparts.com/a18716-tbo-spindle-for-delta-power-tools/ I don't know much about the company other than they make some Delta replacement parts.
Larry
Tom Norton
01-16-2018, 3:36 PM
Tried OWWM but they apparently locked my post out as the machine does not qualify for the site.
Matt Day
01-16-2018, 3:54 PM
Ebay.
———-
Tom Norton
01-16-2018, 4:14 PM
No luck on ebay
Doug Walls
01-16-2018, 4:29 PM
Anyone know of a source for obsolete Delta parts?
It would help to know the model#
Tried OWWM but they apparently locked my post
If OWWM locked your post, Your Delta is probably a Asian-Import!
Several of the import machines may use some of the same parts as Jet & Grizzly.
Doug
Tom Norton
01-16-2018, 5:09 PM
It is a model #17-900
Lee Schierer
01-16-2018, 8:35 PM
Post photos of the damaged spindle. There are methods for repairing machined shafts that may or may not work depending on the type and extent of damage.
Doug Walls
01-16-2018, 10:36 PM
Here's a link to a Grizzly spindle that may match?
http://www.grizzly.com/parts/SPINDLE/P7943089
You could try to call their tech support & possibly check the dimensions.
Doug
Tom Norton
01-17-2018, 7:39 AM
Doug that looks exactly the same. I will call Grizzly today. Thanks!!!
Tom Norton
01-17-2018, 8:36 AM
Doug, I spoke with Grizzly and they will not do any measurements of parts. So I am taking a shot at this part.
Doug Walls
01-17-2018, 12:00 PM
Doug, I spoke with Grizzly and they will not do any measurements of parts. So I am taking a shot at this part.Well it was worth a shot at getting the measurements!
I've found out that a lot of the Asian-Import machines use the same parts.
If it don't match up exactly it could possibly still work with different bearings!
Some of the older Delta & Walker Turner machines used bearings with different in-side dimensions.
The out-side bearing dimensions that matched the machine castings didn't change, But the spindles & arbors ID did seem to change.
Doug
Tom Norton
01-17-2018, 12:58 PM
That is what I was thinking. Fortunately I made a note if the bearing number before the "incident"!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.