Matt Mulvahill
11-25-2017, 8:00 PM
I picked up a late 90s Jet JWTS-10JF (708471) with cast iron wings and a Beseimeyer-style fence for a decent deal. It seemed to be in great shape except for the lift and tilt mechanisms, which were really tough to operate and had signs of grinding metal. Since I had to figure out where the issues with the lift/tilt were, I decided to just dissassemble/clean/reassemble to whole saw.
Jet emailed me the manual (the saw is labeled a JWTS-10, but really its identical to the -10JF). Disassembly was straightforward enough. I used lacquer thinner to remove all of the old grease/oil/dust build-up, wiped contact surfaces with isopropyl alcohol. Then used paste wax on the trunnion contacts and white lithium grease on spinning parts and the worm gears. The worm gear shaft for the lift mechanism had definite grinding between the shaft, a washer, and the eccentric barrel (?) that holds and adjusts the shaft. Sanding and polishing the shaft and barrel and replacing the washer fixed that issue. I’ve also installed the PALS.
I’m at the point of reassembling the trunnions and trunnion brackets and have a question. Everything goes back together, the lift and tilt mechanisms work great, except the front trunnion doesn’t quite sit fully in it’s bracket.
If I remove the rear bracket, I’m able to get the front one fully seated, but the whole trunnion/arbor assembly is then angled towards the saw table (downward as the saw currently is, upward when upright) such that it won’t fit into the rear bracket.
I can’t get the two brackets to both fully seat the trunnions. My latest attempt was to use c-clamps to hold the front one to its bracket, then install the rear one — the front just slipped right back once I removed the clamps.
The photo with the red arrow shows the gap/unseated trunnion.
Is there something I’m missing here? Is it seated well enough? Does it sound like the front trunnion bracket could have warped?
Thanks for the help.
Jet emailed me the manual (the saw is labeled a JWTS-10, but really its identical to the -10JF). Disassembly was straightforward enough. I used lacquer thinner to remove all of the old grease/oil/dust build-up, wiped contact surfaces with isopropyl alcohol. Then used paste wax on the trunnion contacts and white lithium grease on spinning parts and the worm gears. The worm gear shaft for the lift mechanism had definite grinding between the shaft, a washer, and the eccentric barrel (?) that holds and adjusts the shaft. Sanding and polishing the shaft and barrel and replacing the washer fixed that issue. I’ve also installed the PALS.
I’m at the point of reassembling the trunnions and trunnion brackets and have a question. Everything goes back together, the lift and tilt mechanisms work great, except the front trunnion doesn’t quite sit fully in it’s bracket.
If I remove the rear bracket, I’m able to get the front one fully seated, but the whole trunnion/arbor assembly is then angled towards the saw table (downward as the saw currently is, upward when upright) such that it won’t fit into the rear bracket.
I can’t get the two brackets to both fully seat the trunnions. My latest attempt was to use c-clamps to hold the front one to its bracket, then install the rear one — the front just slipped right back once I removed the clamps.
The photo with the red arrow shows the gap/unseated trunnion.
Is there something I’m missing here? Is it seated well enough? Does it sound like the front trunnion bracket could have warped?
Thanks for the help.