Trotec laser will not engrave, only cut???

[Ricard Rinaldo]

I recently bough an old Speedy from year 2000.
It is in fairly good condition and seem to work but I can´t output anything else from Corel but cutlines.
If I draw a square, make it a red hairline - No problem.
Job control works fins and laser cuts.
If I try to add a black square (engraving) and print it, the file in JC is all corrupted and shows up as a mostly black surface and engrave as such.
I am using printer drivers from a laser I sold years ago that was from 2005 and JC 6.5.4.

°Could it be the printer driver that is wrong, cut lines shows up correctly though!??
°I have tried every possible setting I can think of in Corel X4 with same result!
°The test files provided with JC engraves fine!

I have tried finding other drivers but I can´t find anything, anywhere online.
The laser is a 8003 C25 30W.
Very thankful for suggestions as I can´t think of anything else to try. :( :( :(
Here are some picture with job control in background for reference.
In this specific case the raster work is not all black in JC but still corrupted.

372175372174

[Bill George]

Sounds like you either need to contact Trotec USA or go on their website and look for Downloads and get the Driver and Documentation you need.

[Mark Sipes]

I am running JC 6.2.3 with Driver 5.15 , Corel 16 and Xp and have never had a file transfer problem...... I have had the job stop in the middle with an error for signal loss, but that is because I run the machine in the background and it was problem a system overload.


What DPI 125/250/333/500/600/1000 are you running. there is a max dpi/ image / file size complexity issue.

.

[Dan Hill]

To engrave, the square needs to be RGB, if it is CMYK the laser only sees what you described.