PDA

View Full Version : Epilog Legend 36EXT garage set up



Dianna Riggs
11-18-2017, 2:29 PM
New to the business. Bought a used Epilog Legend 36EXT and have it in the garage. Cannot have it 3 ft from the back wall as recommended so am wondering if I can just put cement board behind the machine instead? If so, how much does it need to extend above and to the side?
In videos they are often up against concrete walls so I dont know why 3 ft was suggested ?

Bruce Volden
11-18-2017, 7:55 PM
Dianna,

My machines fit out far away enough from the wall/s so I can get behind and clean, monitor (idiot lights for problems), access cables......
As far as the cement board? you're not exhausting "heat", just fumes etc.
I would not like my machines inaccessible in the rear. HTH

Bruce

Dianna Riggs
11-18-2017, 9:02 PM
Dianna,

My machines fit out far away enough from the wall/s so I can get behind and clean, monitor (idiot lights for problems), access cables......
As far as the cement board? you're not exhausting "heat", just fumes etc.
I would not like my machines inaccessible in the rear. HTH

Bruce

Thanks for responding Bruce. I have limited space in the garage so cannot have it sticking out too far from the wall. I was under the impression that they produced heat at the back so I was not supposed to have it against a plywood wall. I was thinking I would get a couple of concrete backer type sheets to put behind to create a fire barrier from the plywood. But based on what you are saying, that is not necessary?? It look like you have newer machines, so is it maybe the older Epilogs that produce heat? I would like to get it hooked up, leveled, calibrated, etc. so I can learn how to operate.

Thanks,
Dianna

Joe Pelonio
11-18-2017, 10:10 PM
A former colleague bought two of those used, both dual head back in the late 90s. They were against the wall in his garage, and never had any problems. I used them a few times, and the wall was just drywall.

Dianna Riggs
11-18-2017, 11:10 PM
Thank you Joe. I will hook it up and see if I can get it running. If it produces too much heat I will look at options then. First the fun part of getting it all hooked up, leveled and calibrated. Should be interesting....

Keith Outten
11-19-2017, 3:40 PM
I've never had a problem with heat and I park my laser (and previous machines) about 8" from a sheet rock wall. It's on wheels so moving it away from the wall for maintenance is easy.

Chuck Phillips
11-20-2017, 8:33 AM
Epilog recommends keeping the machine away from the wall to keep the machine cool, not the wall. It's about air flow behind the machine.

A big problem you will have in a garage is environmental. Dust and heat are enemies of your laser tube. Dust and cob webs will build up inside the machine and inhibit cooling. No/poor climate control will make the problem worse. The machine will eat laser tubes if don't have the proper environment.

Dianna Riggs
11-20-2017, 12:18 PM
Thanks Chuck. That makes sense. It is a heated garage so not too much temperature fluctuation. I keep it covered when not in use to cut some of the dust, but will be more vigilant about regulating the environment.
Thanks,
Dianna