John Edwards
11-03-2005, 6:55 PM
Thought you folks might like a couple shots of the infamous Dovetail plane.
Here are two of my three.
With the proper setup(s) it will cut male and female dovetails, Sliders and tapered dovetails. Even the teeth on a gear, if one was so inclined.
Also included are a shot of the 146/7/8 Tongue and Groove planes. Each is designed to cut a tongue and groove joint. Centered on a different thickness.
146 does 3/8, 147 5/8 and the 148 centers on a 7/8 thickness.
The plane is pushed one way cutting the groove. Then turned end for end to cut the tongue.
Kinda cool way to join edge jointed boards.
Thanks
John Edwards
Here are two of my three.
With the proper setup(s) it will cut male and female dovetails, Sliders and tapered dovetails. Even the teeth on a gear, if one was so inclined.
Also included are a shot of the 146/7/8 Tongue and Groove planes. Each is designed to cut a tongue and groove joint. Centered on a different thickness.
146 does 3/8, 147 5/8 and the 148 centers on a 7/8 thickness.
The plane is pushed one way cutting the groove. Then turned end for end to cut the tongue.
Kinda cool way to join edge jointed boards.
Thanks
John Edwards