Terry Kelly
11-02-2017, 10:28 PM
So,I’m just getting back into playing around with the shop tools after a hand-Full of years away..
.I’m going to finally build the router table I want to build before....I’ve had the lift and the hardware and router here since before my break away.....I was looking over the plans which are the Norm Abrahms upgraded version...making a cut list and noticed a note saying all measurements based off the plywood being exactly3/4” thick if not then make adjustments...I plan on using Baltic Birch plywood which is 18mm or 11/16” thick.....I’m thinking the adjustments they are noting are when I make the dado cuts....Do You Agree or am I missing something else?
Thank You for any and all responses......
Its good to be back.....
.I’m going to finally build the router table I want to build before....I’ve had the lift and the hardware and router here since before my break away.....I was looking over the plans which are the Norm Abrahms upgraded version...making a cut list and noticed a note saying all measurements based off the plywood being exactly3/4” thick if not then make adjustments...I plan on using Baltic Birch plywood which is 18mm or 11/16” thick.....I’m thinking the adjustments they are noting are when I make the dado cuts....Do You Agree or am I missing something else?
Thank You for any and all responses......
Its good to be back.....