Ernest Martin
11-02-2017, 11:22 AM
Well I'm having a problem with my laser in scanning mode, maybe somebody else has had this problem already, and can help, or any suggestions
It seems when I'm engraving the edge that leads in is under powered which can be seen in the pictures I added,
these engraved rectangles are 1/2''x 1'' engraved at 300 mm/s at 40% power
370834370835370836
the green box was done in X_unilateralism mode so the right side is not very sharp looks like it just didn't engrave as deep or as much power
the left side is nice and sharp all the way to the end.
The blue box was done X-swing the picture is not very sharp but the first line on the right is not very sharp to begin with but the end is nice and sharp then the lines alternate the rest of the way down.
The rest of the boxes were just samples that I was playing with
I feel that its not a lens mirror issue but rather a software or machine since its always the leading edge.
The last image shows the preview screen in RDworks it shows a pink line on the beginning of the first line and the end of the second line which is also kinda were it doesn't engrave properly
any help would be appreciated so I can quit pulling out my hair
It seems when I'm engraving the edge that leads in is under powered which can be seen in the pictures I added,
these engraved rectangles are 1/2''x 1'' engraved at 300 mm/s at 40% power
370834370835370836
the green box was done in X_unilateralism mode so the right side is not very sharp looks like it just didn't engrave as deep or as much power
the left side is nice and sharp all the way to the end.
The blue box was done X-swing the picture is not very sharp but the first line on the right is not very sharp to begin with but the end is nice and sharp then the lines alternate the rest of the way down.
The rest of the boxes were just samples that I was playing with
I feel that its not a lens mirror issue but rather a software or machine since its always the leading edge.
The last image shows the preview screen in RDworks it shows a pink line on the beginning of the first line and the end of the second line which is also kinda were it doesn't engrave properly
any help would be appreciated so I can quit pulling out my hair