Bruce Jones
10-24-2017, 12:38 PM
Hello everyone, about a month ago I had turned a platter in Cherry to do some Pyrography on but the fire in the grain of that piece was so nice I couldn't bring my self to burn it. So I turned another piece this time it was a Teak platter just under 16" D and was going to do a Pyro fall pattern on it, but after looking at this piece I thought I would hand carve the Embellishment into the project and also pierce threw leaving a floating rim. All the work is hand done the only power tool used was the lathe. The name comes from when I started to come up with this idea back on September 22nd. I hope you all like it
C&C Welcome, Teak 16" D Varnish finish
Bruce
C&C Welcome, Teak 16" D Varnish finish
Bruce